Choose a state

454 Arkansas HVAC Class D (2018-01-01)

60 multiple-choice questions
Open book
3-hour time limit
Class D license permits holder to perform sheet metal work as it relates to ductwork for HVACR systems without regard to or limitation of horsepower of the system to which the duct connects. The licensee in this category is prohibited from the sale, installation, and service of HVACR equipment and systems.

The reference material listed below was used to prepare the questions for this examination.  The examination may also contain questions based on trade knowledge or general industry practices. Except for Code books, you can base your answers on later editions of references as they become available.  For Code questions, the examinations will be based only on the edition of the Code book that is listed.

These products apply to test outline dated 2018-01-01

Click Here to View the Candidate Information Bulletin Click Here to View the Candidate Information Bulletin



Open Book These books are allowed while taking your test.
Closed Book These books are for pre-test study only and are not available for use during the test.
In Stock These books are currently in stock.
Out of Stock These books are currently out of stock.

  • Open Book In Stock

    Blank Quick Reference Tabs

    $13.00

  • Open Book In Stock

    Arkansas Fuel and Gas Code

    $86.54

  • Open Book In Stock

    Arkansas Mechanical Code

    $87.50

  • Open Book In Stock

    Arkansas HVAC License Rules and Regulations

    $0.00

    Rules and Regulations pertaining to the HVAC license.

  • Open Book In Stock

    Arkansas HVAC/R Law, Title 17, Chapter 33

    $0.00

    Arkansas Code 1987, Annotated Title 17  Chapter 33  

  • Open Book Out of Stock

    HVAC Duct Construction Standards, Metal and Flexible

    $300.00

    The third edition of the HVAC Duct Construction Standards – Metal and Flexible is intended primarily for commercial and institutional duct construction. This American National Standard contains tables and details for constructing ductwork for ½" to 10" wg positive and negative pressures. This edition improves upon the second edition with expanded pressure class tables, separate tables for TDC/TDF construction and expanded tables for round duct construction including 6" wg positive and negative pressure and sizes up to 96". New in this edition is an engineering and design chapter to provide additional information to design professionals, double-wall construction details, new casing construction details and additional accessory items. The standard is applicable for construction using uncoated steel, galvanized and stainless steels and a limited range of aluminum ducts. This standard has been adopted in the ICC International Mechanical Code.