Choose a state

GA-RLC Residential - Light Commercial (2022-05-09)

08/Numbers of Questions - 90
Minimum Passing Score - 70%
Time Allowed - 230 Minutes

The reference material listed below was used to prepare the questions for this examination.  The examination may also contain questions based on trade knowledge or general industry practices. Except for Code books, you can base your answers on later editions of references as they become available.  For Code questions, the examinations will be based only on the edition of the Code book that is listed.

These products apply to test outline dated 2022-05-09

Click Here to View the Candidate Information Bulletin Click Here to View the Candidate Information Bulletin



Open Book These books are allowed while taking your test.
Closed Book These books are for pre-test study only and are not available for use during the test.
In Stock These books are currently in stock.
Out of Stock These books are currently out of stock.

  • Open Book In Stock

    Technical Digest No. 9 - Handling and Erection of Steel Joists and Joist Girders

    3rd Edition
    Publication Year: March 2006

    $45.00

    This updated Technical Digest contains a thorough coverage of the proper handling and erection procedures to be employed in the field to make certain that SJI joist products are not damaged, that they perform as specified, and above all, to ensure the safety of the erectors. The digest includes descriptions of the standard products: K-Series joists, LH/DLH-Series joists, Joist Girders and now CJ-Series joists, how joist products are prepared, tagged, loaded and shipped from the joist manufacturer’s plant, how they are to be unloaded and stored at the job site, how the joist products are to be erected including bridging, and field inspection. Other topics covered in the digest are penalized erection and common field issues. This edition contains information related to the newest standard joist product, the CJ-Series joists that were introduced in 2007. It also includes updated information on Bridging in Chapter 8 as well as some additional topics added to the list of Miscellaneous Topics - Common Field Issues in Chapter 9. General contractors, steel erectors, inspectors, and building officials would most benefit from this Technical Digest. Engineers and Architects would also benefit from the information contained in the digest if part of their responsibilities is to oversee joist and Joist Girder projects under construction.

  • Open Book In Stock

    Pipe and Excavation Contracting 2011

    Publication Year: 2011

    $50.00

    This popular manual has been updated and improved to bring it more current with modern earth moving and trenching equipment, refined excavation techniques, stricter safety rules, and improved materials. Here you’ll find how to enter and succeed in the underground utility business. Includes hands-on instructions for operating the equipment and doing the trenching, pipe laying and connecting work and answers to what causes so many skilled equipment operators and pipe layers to fail when they try to start their own business.

  • Open Book In Stock

    Gypsum Construction Handbook 7th Edtion

    Publication Year: 2014

    $75.00

    The tried-and-true Gypsum Construction Handbook is a systematic guide to selecting and using gypsum drywall, veneer plaster, tile backers, ceilings, and conventional plaster building materials. A widely respected training text for aspiring architects and engineers, the book provides detailed product information and efficient installation methodology. The Seventh Edition features updates in gypsum products, including ultralight panels, glass-mat panels, paperfaced plastic bead, and ultralightweight joint compound, and modern specialty acoustical and ceiling product guidelines. This comprehensive reference also incorporates the latest in sustainable products.

  • Open Book In Stock

    International Residential Code for One and Two Family Dwellings 2018

    Publication Year: 2018

    $150.00

    This comprehensive code comprises all building, plumbing, mechanical, fuel gas and electrical requirements for one- and two-family dwellings and townhouses up to three stories. For the most current adoptions details go to International Code AdoptionsThe IRC contains many important changes such as:An updated seismic map reflects the most conservative Seismic Design Category (SDC) based on any soil type and a new map reflects less conservative SDCs when Site Class A, B or D is applicable.The townhouse separation provisions now include options for using two separate fire-resistant-rated walls or a common wall.An emergency escape and rescue opening is no longer required in basement sleeping rooms where the dwelling has an automatic fire sprinkler system and the basement has a second means of egress or an emergency escape opening.The exemption for interconnection of smoke alarms in existing areas has been deleted.New girder/header tables have been revised to incorporate the use of #2 Southern Pine in lieu of #1 Southern Pine.New tables address alternative wood stud heights and the required number of full height studs in high wind areas.

  • Open Book In Stock

    International Building Code 2018

    Publication Year: 2018

    $155.00

    The scope of the International Building Code® (IBC®) includes all buildings except detached one- and two-family dwellings and townhouses up to three stories. For the most current adoptions details go to International Code Adoptions The 2018 IBC contains many important changes such as:Accessory storage spaces of any size are now permitted to be classified as part of the occupancy to which they are accessory. New code sections have been introduced addressing medical gas systems and higher education laboratories. Use of fire walls to create separate buildings is now limited to only the determination of permissible types of construction based on allowable building area and height. Where an elevator hoistway door opens into a fire-resistance-rated corridor, the opening must be protected in a manner to address smoke intrusion into the hoistway. The occupant load factor for business uses has been revised to one occupant per 150 square feet. Live loads on decks and balconies increase the deck live load to one and one-half times the live load of the area served. The minimum lateral load that fire walls are required to resist is five pounds per square foot. Wind speed maps updated, including maps for the state of Hawaii. Terminology describing wind speeds has changed again with ultimate design wind speeds now called basic design wind speeds. Site soil coefficients now correspond to the newest generation of ground motion attenuation equations (seismic values). Five-foot tall wood trusses requiring permanent bracing must have a periodic special inspection to verify that the required bracing has been installed. New alternative fastener schedule for construction of mechanically laminated decking is added giving equivalent power-driven fasteners for the 20-penny nail. Solid sawn lumber header and girder spans for the exterior bearing walls reduce span lengths to allow #2 Southern Pine design values.

  • Open Book Out of Stock

    Georgia State Amendments to the State Minimum Standard Codes

    $23.50

  • Open Book In Stock

    International Building Code Turbo Tabs 2018

    Publication Year: 2018

    $18.00

    2018 IBC Turbo Tabs consist of clear plastic self-adhesive tabs that have key sections of the 2018 International Building Code printed on them in an easy-to-read format. Can be used with either the 2018 International Building Code or the 2018 IBC Code and Commentary.

  • Open Book In Stock

    International Residential Code for One and Two Family Dwellings Turbo Tabs 2018

    Publication Year: 2018

    $18.00

    2018 IRC Turbo Tabs consists of clear plastic self-adhesive tabs that have key sections of the 2018 International Residential Code printed on them in an easy-to-read format. Can be used with either the 2018 International Residential Code or the 2018 IRC Code and Commentary.

  • Open Book In Stock

    Carpentry and Building Construction, 2016 Student Edition

    Publication Year: 2016

    $105.00

    **IN STOCK**

    Carpentry & Building Construction is a comprehensive carpentry program that focuses on residential construction with many procedures also applying to light commercial construction. The informative text provides detailed, heavily illustrated information about materials, tools, and processes, with many step-by-step procedures.

  • Open Book In Stock

    SDI (Manual of Construction with Steel Deck) Edition 3

    Publication Year: 2017
    3RD Edition

    $50.00

     

    The new Third Edition of the Steel Deck Institute Manual of Construction with Steel Deck (MOC3) continues the tradition established by earlier editions to provide information necessary for the proper field usage of steel deck. This edition is reformatted for easier use with updated references, including those for the SDI QA/QC Standard for Quality Control and Quality Assurance for Installation of Steel Deck.

  • Open Book In Stock

    BCSI: Guide to Good Practice for Handling, Installing, Restraining, and Bracing of Metal Plate Connected Wood Trusses 2018

    Publication Year: 2018

    $49.00

    BCSI includes information and guidance pertaining to diagonal bracing for web members with two rows of lateral restraint, as well as permanent lateral restraint and diagonal bracing guidance for trusses spaced wider than 2' o.c. With references to building codes, standards and OSHA regulations, BCSI consists of ten chapters that contain the most current information regarding the handling, installing, restraining, and bracing of metal plate connected wood trusses.

  • Open Book In Stock

    Contractors Guide to Quality Concrete Construction 4th Edition

    Publication Year: 2018
    4th Edition

    $125.00

    This document is published jointly by the American Concrete Institute (ACI) and the American Society of Concrete Contractors (ASCC). It has been reviewed in accordance with the Educational Committee Manual document review procedures of the ACI Educational Activities Committee. ACI and ASCC reports are intended for guidance in planning, designing, executing, and inspecting construction. This document is intended for the use of individuals who are competent to evaluate the significance and limitations of its content and recommendations and who will accept responsibility for the application of the material it contains.

    Now 262 pages – over 100 pages longer than the previous edition – the guide includes full-color photos and illustrations, a new, easier-to-read layout, and substantial content updates. Also included in the fourth edition are 43 Position Statements from ASCC, details on ACI Certification programs, and an appendix introducing several legal issues of interest to concrete contractors. A summary, review questions, and additional recommended reading list accompany each of the 12 chapters.

    Published 2018

  • Open Book In Stock

    Modern Masonry: Brick, Block, Stone 9th Edition

    Publication Year: 2020

    $125.00

    Modern Masonry: Brick, Block, Stone provides a broad understanding of the properties and applications of masonry materials. It begins with coverage on careers to help students learn about the industry. It then progresses to teaching safe and proper procedures for working with brick, block, and stone. Coverage of concrete form construction and flatwork is also included. Green features address specific topics relating to masonry’s impact on the environment.